To store taxidermy safely, keep it somewhere the humidity stays steady (museum guidance is 45% to 55% relative humidity), out of direct sun, away from heaters and damp floors, and covered or closed in so dust and insects can't settle on it. To move it, fasten each mount to plywood through its backboard, lay the big pieces on their backs on the floor, keep the heavy ones low, and pad against the framing rather than the hair.
The rest of this guide explains why each of those matters, using conservation guidance written for museums and the experience of hunters who've moved whole trophy rooms. For everyday dusting and upkeep, see our taxidermy care guide.
What humidity and temperature do mounts need?
Steady humidity matters more than the exact temperature. The Canadian Conservation Institute, which advises museums on mounted specimens and pelts, recommends 45% to 55% relative humidity. Above 65% there's a risk of mold; very dry air can make skins brittle and crack; and fast swings stress the different materials in a mount until they split or tear. It also suggests keeping temperatures under 25 C (77 F), though it calls that less critical than humidity (CCI Notes 8/3). The UK's Institute of Conservation gives the same 45% to 55% band for stores, and a temperature kept as steady as you can manage within 10 C to 22 C, about 50 F to 72 F (Icon).
Experienced members say the same thing in plainer words. When a member planning a garage trophy room in upstate New York asked whether a wood stove would do, one experienced member answered that it isn't really heat or cold that hurts mounts, it's the change in humidity. He said he'd kept mounts in storage units below freezing and in Arizona and Reno heat, that wood stoves are the worst heat source because humidity is so hard to control, and that skin takes on and gives off moisture, swelling and shrinking until it cracks. Clients of his with humidity-controlled rooms had mounts still perfect after some 20 years (AfricaHunting, 2015). Another member relayed that a taxidermist in Yellowknife told him cold alone won't affect mounts, though he also advised against a wood stove (AfricaHunting, 2015).
You'll see other numbers online. One AfricaHunting member suggested 70% humidity, and a Colorado owner replied that his air rarely gets that wet (AfricaHunting, 2017). We'd follow the museum figure: 70% is past the CCI's 65% mold line. In a dry climate a humidifier helps, but the same member's caution is a good one: don't let it blow straight on a mount. A cheap hygrometer in the room tells you where you actually are.
Will sunlight or lamps fade taxidermy?
Yes, and fading doesn't reverse. The CCI says light, both visible and ultraviolet, discolors fur and feathers: dark colors fade and light ones turn yellow, and the only prevention is limiting exposure. Its guideline for displaying fur is no more than 50 lux, and it suggests storing specimens in the dark.
Hunters see the same thing at home. In a HuntingNet thread from a member about to hang deer mounts in a sunny room, replies said sun will fade and bleach the hair, while the antlers should be fine, and suggested checking whether new windows already block UV (HuntingNet, 2007). Another reply, signed by a taxidermist with a studio site, added that the heating and cooling near a sunny window makes the skin expand and contract and can crack mounts that weren't professionally tanned. He said UV sprays and window films help only slightly with that heat, and that fully reflective film works but darkens the windows (HuntingNet, 2007). Panhandle Taxidermy, a Nebraska studio, puts it simply on its care page: keep mounts out of direct sunlight and away from high heat or humidity (Panhandle Taxidermy).
Does window film work?
It helps with UV. In a 2020 AfricaHunting thread about a trophy room with big south-facing windows (AfricaHunting, 2020):
- One member said windows roughly 20 years old or newer may already have a low-e coating, and that holding a lighter up to the glass and looking for a reflection off the inner pane is a rough check.
- The same member suggested leaving a sheet of colored construction paper on your floor for a couple of weeks and checking how much it fades.
- Another suggested blinds or drapes closed during the hours the sun hits.
- The owner decided on a 3M film and reported that it removes 99.9% of UV, by his account.
- One member had bought a UV spray sold for taxidermy, Mount Protect, but said he couldn't vouch for it.
What about room lights?
Direct indoor light fades pigment too, and hot bulbs add heat and humidity swings. One AfricaHunting member's fix was indirect lighting plus temperature and humidity control (AfricaHunting, 2017). The owner who asked planned to swap incandescent track lights for LEDs to cut the heat and used ceiling fans against heat building up near the ceiling. Icon adds a point about showcases: lights switched on and off every day can drive the humidity up and down inside a case, and swings that are fast or large enough can split bone. If you keep a small mount under a taxidermy glass dome or in a case, keep strong lights off it.
What else in a room damages mounts?
- Smoke. One HuntingNet member said tobacco smoke leaves a film that discolors hair, and another described an old rack mount kept in a clubhouse for years that turned very dark, with capes in the same building changing color too (HuntingNet, 2005).
- Heat sources. The CCI says to keep specimens away from radiators and lights, which cause local heating.
- Water. It also warns against spots near uninsulated pipes, where condensation and damp are a risk, on concrete floors, or anywhere a leak could reach.
- Insects. Clothes moths and carpet beetles can wreck fur in days, according to the CCI, which suggests checking stored mounts every three months. Our page on carpet beetles in taxidermy covers signs and treatment.
- Rodents. The Cedar Ridge Chronicles filmed the repair of a whitetail whose nose and lip were chewed by mice while it sat in a friend's storage building (How to Repair a Damaged Deer Nose, 2024).
Can you store taxidermy in a garage, attic or storage unit?
Only if you can control what's above: humidity, heat, light, insects and rodents. Many garages, attics and storage units can't. If you have no other choice, put the mount in the most stable spot you have, raise it off a concrete floor, keep it away from the walls with pipes and the door that lets in weather, and check it every few months.
How do you store mounts long term?
- Clean it first. Dust is abrasive and feeds insects and mold, according to the CCI. A soft brush in the direction of the hair is enough; see how to dust a deer head.
- Cover it, but let it breathe. The CCI suggests closed cabinets or boxes, or a loose cover of clean, tightly woven cotton sheeting. Plastic sheeting works only if it's tented so it doesn't touch the mount. Icon recommends closed cupboards for taxidermy to keep dust and pests off.
- Keep air moving. The CCI says ventilation, such as a fan, helps prevent insects and mold in storage areas.
- Handle it by the base. Rough handling is a major cause of damage to mounts, which are rigid, and the CCI's advice is to lift by the base. It also warns that hair on older deer-family mounts can be brittle.
- Check it on a schedule. Every three months, look for loose hair, fine dust under the mount and larvae.
- Freeze small pieces if you find insects. Icon describes sealing a specimen in a plastic bag and freezing it in a domestic freezer at -18 C for at least 14 days.
Old mounts need one more precaution. The CCI notes that some older skins were treated with arsenic, mercury or DDT, so wear nitrile gloves and a particle mask when handling one. Our vintage taxidermy page explains how to tell.
How do you move taxidermy without damaging it?
The best advice we found comes from two long AfricaHunting threads by members moving whole trophy rooms, one from New York to Georgia in 2016 and one from Houston to Montana in 2022. Put together, it looks like this:
- Fasten each mount to plywood. Members used 3/4 inch plywood and ran screws through it into the back of each mount. One member's reply was simply "Use more screws, always more screws" (AfricaHunting, 2022).
- Think like a shipping crate. The same member suggested putting the biggest pieces on their backs on the floor and the heavy ones low. Another explained why: with the mount on its back, antlers and horns can't swing and lever against the spot where they're joined to the form (AfricaHunting, 2022).
- Make the boards easy to lift and hard to shift. One member screwed 2x4s under his plywood so he could get his fingers underneath, slid everything in from the back of the trailer, and added short 2x4 blocks on top near the ends so one section couldn't bounce up over the next (AfricaHunting, 2022).
- Pad the frame, not the face. A member who'd just moved with a taxidermist friend's help said to pack between the framing but not against the mounts themselves, since anything touching will rub (AfricaHunting, 2022). Others suggested egg crate foam around horns and bubble wrap taped around the big ones where horns meet the form.
- Test it before the highway. One member said to picture a hard stop, a big bump and a swerve, and to try a hard stop at home to see what breaks loose (AfricaHunting, 2022). A carpenter in the thread said to check the load after the first 300 yards and every time you stop for fuel (AfricaHunting, 2022).
Members hauled their boards in trailers, and one suggested renting or borrowing a fairly large enclosed trailer (AfricaHunting, 2016). One member also carried part of his collection in the cab of his pickup, with his kudu in the passenger seat (AfricaHunting, 2016). If a mount rides in a car, carry it by the backboard or base, keep the antlers clear of the roof and doors, and wedge it so it can't tip.
Do removable horns and antlers help?
A lot. In a 2017 AfricaHunting thread, several members with kudu and gemsbok mounts said their horns just slip on and stay put by gravity, which makes moving far easier (AfricaHunting, 2017). One member had his glued down later by a local taxidermist and called it very inexpensive. Another found his elk's removable antlers spread at the tips under their own weight and was advised to add a set screw behind the burr.
If you're ordering a big mount and expect to move, ask about it up front. Outback Taxidermy in Youngsville, North Carolina lists detachable antlers as an added $300 per side (Outback Taxidermy), and Knight's Taxidermy in Anchorage lists $500 for caribou or elk and $600 for moose on its 2025 list (Knight's Taxidermy). Those are each one studio's price.
Should you hire a pro to move a trophy room?
For a large collection, members leaned that way. One wrote that larger taxidermy studios can move you if you want more than one quote (AfricaHunting, 2016), another said his New Mexico taxidermist recommends a dedicated trophy moving service (AfricaHunting, 2016), and a third had professional haulers bring his mounts from Pennsylvania with everything screwed to plywood walls and the heavier pieces low (AfricaHunting, 2022). Knight's Taxidermy lists crating as priced per job. None of the threads gave a moving price, so get quotes. One member guessed a pro makes more sense for 45 heads and some big pieces than for 15. Ask the studio that mounted your animals; you can also find one in our taxidermist directory.
What should you do after the move?
Unpack in the room where the mounts will live and check every antler joint, ear and seam. Hang them away from windows, vents and fireplaces, using the stud and anchor advice in how to hang a mount, and plan the layout with our trophy room ideas. If something did crack or break on the road, our guide to taxidermy restoration covers what can be fixed and what it costs.
Frequently asked questions
What humidity is best for taxidermy?
Museum guidance from the Canadian Conservation Institute and the UK's Institute of Conservation is 45% to 55% relative humidity, kept steady. Above 65% raises the risk of mold.
Can taxidermy be stored in a cold garage?
Cold alone isn't the main danger, according to one member who's stored mounts below freezing and a taxidermist quoted in the same thread. Swings in humidity, mice, insects and damp floors are bigger risks. If the garage can't stay steady and sealed, find somewhere else.
Does sunlight damage deer mounts?
Yes. Sun fades and bleaches the hair, and the heating and cooling near a window can crack some mounts. Antlers hold up better. Keep mounts out of direct sun or use UV-blocking window film.
How do you pack a deer head for moving?
Screw it to a sheet of plywood through the backboard, pad around the framing rather than the face, and lay it on its back if space allows. Wrap the antlers where they meet the form.
Should I wrap mounts in plastic for storage?
Not tightly. The CCI suggests closed cabinets, boxes or a loose cotton sheet, and plastic only if it's tented so it doesn't touch the mount.