GuidesBy Taxidermy Hobbyist Editorial TeamUpdated November 22, 2026

How to Clean a Deer Mount Without Damaging It

To clean a deer mount, blow the dust out first with low-pressure air, working top down with the grain of the hair. Then brush or wipe the hair in the same direction with a soft brush or a barely damp cloth, clean the glass eyes with a little glass cleaner on a swab, and wipe the nose and antlers gently. Skip soaking and harsh sprays. Below is the routine taxidermists show their own customers, step by step.

How do you clean a deer head mount step by step?

Take the mount down if you can, blow it out, brush and wipe the hair and antlers with the grain, then clean the eyes and nose. Ashley Eve, a taxidermist, follows this order in a 2023 video where she cleans her own first deer mount after about five years on her parents' wall, and it's the method she recommends to her clients.

  1. Take it down safely. Ashley Eve lifts a shoulder mount with one hand on the brisket and one under the chin. If you'd rather not take it down, Stewart of Monarch Taxidermy points out that a plug-in blower lets you clean it on the wall from a step stool or ladder.
  2. Blow the dust out. Use canned air, an air compressor or even a hair dryer, always with the grain. Her reason for not wiping first: a rag can pack dry dust into the hair.
  3. Brush with the grain. She uses a horse grooming brush, or any softer, thicker-bristled brush, until no more dust comes off. Her video description warns against a wire brush, which can leave streaks in the hair.
  4. Wipe the hair. She sprays Windex on a paper towel, not on the deer, and wipes with the grain. Spraying the mount directly adds moisture that can turn to mold if it doesn't dry.
  5. Clean the eyes and nose. A corner of the towel with a little glass cleaner goes on the glass eye. Exposed skin around the eye and the nose pad get only the gentlest wipe.
  6. Smooth the back. When the mount goes back up, she runs her hands along the back edge so the hair lies flat against the wall.

What should you use to clean a deer mount?

Air, a soft brush and a soft cloth do most of the work. Taxidermists add glass cleaner for the eyes, and Monarch Taxidermy uses furniture polish on a wooden plaque. One HuntingNet member who advises her customers wipes mounts with household alcohol, and a Rokslide member who used to prepare fur for auction used a dab of dish soap on a dry rag.

Tool or productWhat it's forWho uses it
Dog groomer blower with a low settingBlowing dust out of hollow deer hairStewart, Monarch Taxidermy (GOHUNT video, 2020)
Canned airSame job without a groomerAshley Eve; a HuntingNet member (2004)
Soft, thick brush or a dusterLifting dust with the grainAshley Eve; Lee Richards
Hot, damp terry clothWiping and setting the hair, eyes and noseStewart, Monarch Taxidermy
Glass cleaner on a cotton swab or ragGlass eyes, fingerprintsStewart; Ashley Eve; Lee Richards
Pledge or Old EnglishThe wooden plaque or base onlyStewart, Monarch Taxidermy

Stewart's damp-towel method is worth knowing. In the GOHUNT video he soaks a terry cloth in water as hot as his hands can take, wrings it out until it's only damp, and wipes from the top down with the grain. He says it trains the hair back into its pattern without the abrasion of a brush and picks up the dust the blower missed, with no residue left behind. He also warns against a garage compressor with an air nozzle, which can break the hair. Deer have hollow hair that bends and gets damaged if you hit it against the grain, and a mount that's hung for 20 years, maybe with some sun damage, is more brittle.

Lee Richards, a Texas taxidermist who went full time in 1979, gave the Dallas Morning News a similar routine in 2020: a Swiffer or feather duster, then a damp, not wet, cloth, always with the hair. For a badly soiled mount he goes outside with an air compressor, holding the nozzle 6 to 12 inches away at medium pressure.

Forum members report other cloths. A HuntingNet member who tells her customers to use household alcohol said it dries instantly and leaves no residue on fur (2004). A Rokslide member who used to put up fur for auction described a little Dawn dish soap on a rag, no water, rubbed in the direction of the hair and wiped again with a clean dry rag once dry (2022). He used it on coyotes and wolves and assumed it would work for deer as well.

Some of the product links below are affiliate links. Taxidermy Hobbyist may earn a commission on qualifying purchases at no extra cost to you. See our affiliate disclosure.

If you're putting a kit together: canned air, a soft grooming brush, terry cloth towels and cotton swabs for the eyes.

What should you never use on a deer mount?

Never soak a mount or spray cleaner straight onto it, never use a wire brush, and never blow high-pressure air against the grain. Put a vacuum nozzle near the hair only through a screen. On an older mount, go even lighter: the hide and hair get more fragile with age.

A worker in a taxidermy shop explained the soaking rule on Rokslide: his shop dry cleans older mounts, because over time the acid used in tanning can rot a hide, and a soaked acid-rotted hide will turn into wet newspaper (2022). The Canadian Conservation Institute notes that hair on older deer-family specimens can be brittle enough to pull out or break off under a brush or vacuum. The CCI also warns that some older mounts were treated with arsenic or other toxic pesticides, so wear gloves on anything old.

How do you clean the antlers, eyes and nose?

Wipe antlers with a damp cloth. A light coat of oil adds sheen if you like it, but never put anything on wild sheep horns. Glass eyes take a swab of glass cleaner, and the nose gets a damp cloth so you don't lift its painted finish.

Stewart of Monarch Taxidermy covered each part. Antlers are durable, so a wet cloth is all most need; for owners who want a sheen, he suggested a very light coat of linseed oil, adding that most people like antlers natural. Sheep horn is the exception: no cleaners, polish or oil, because anything on it is likely to darken it and stain it for good. For a fingerprint on a glass eye, it's glass cleaner on a Q-tip, one end wet and one end dry. For the nose, a hot wet cloth won't take off the paint or finish. If an old nose has lost its wet look, he said a local taxidermist can spray some back on, or you can brush on a little clear coat.

Lee Richards wipes antlers with a damp rag and uses a light touch of WD-40 on a rag only on light-colored antlers, since oil darkens dark antlers too much. He keeps oil off sheep and antelope horns entirely, saying it'll turn them black, though Stewart says black horn such as pronghorn takes a little WD-40 if you like a darker look. Not every writer agrees on products: in Game & Fish (2025), Mike Gnatkowski suggests Murphy's Oil Soap cut half and half with water for antler shine and a little petroleum jelly around the eyes and nose. If antlers have faded or bleached, our guide to restoring antler color covers what holds up.

How do you get a smoke smell out of a mount?

Start with time and air: hang the mount or hide where air moves, out of direct sun and rain, for about a week. If it still smells, hunters suggest baking soda left in the hair for a couple of days and then shaken out, or ozone treatment in a closed space. Skip vinegar, which one member warned might cause hair slippage.

Those ideas come from a 2023 Hunt Talk thread about an estate-sale bear hide that smelled of cigarettes and bacon cooked in cast iron. One member suggested a covered patio with good airflow for a week before anything else. Another suggested sprinkling baking soda, rolling the hide hair side in and leaving it bagged for a couple days before shaking it out. A third said ozone helps but needs to be in a chamber, and one member warned that vinegar might cause slippage. The thread doesn't say which one worked, so try them gentlest first.

Years of smoke also stain hair. A HuntingNet member said tobacco smoke discolors hair horribly (2005). Cleaning won't always bring that color back; at that point it's a job for deer mount repair.

How often should you clean a deer mount?

Dust lightly often, and do a full clean with a close look for bugs once a year. Monarch Taxidermy recommends the yearly clean, the Canadian Conservation Institute says specimens on open display need dusting at least twice a year, and one Rokslide owner said he dusts monthly with a soft dust rag (2022).

The yearly clean doubles as an inspection. Stewart says loose hair, a little sawdust-like dust or tiny moth husks are the warning signs, and that catching them early can save the other trophies in the room. The rest of the routine, from humidity to sunlight, is in our guide on how to dust a deer mount and look after it. If you're weighing a new one, our deer head mount guide covers what's involved. Feathers and painted fish skin need a different touch, covered in cleaning feathers and fish skin.

Frequently asked questions

Can you use a vacuum on a deer mount?

Not directly. The Canadian Conservation Institute says never to put a vacuum nozzle on a specimen; museums brush toward a nozzle covered with gauze or plastic screening so loose parts aren't lost.

Is it normal for an old deer mount to shed?

No. A Rokslide member said shedding means the mount is deteriorating because bugs are eating it, and a taxidermy shop worker added that hair lost that way can't really be reversed. Have a taxidermist look at it before it spreads.

Can you clean a deer mount with water?

Only a damp cloth, never a soak. Monarch Taxidermy wipes with a well-wrung hot towel and Lee Richards with a cloth that's damp, not wet; a shop worker on Rokslide warns that soaking an old acid-rotted hide can ruin it.

Need a Professional?

Browse taxidermy studios, schools, suppliers and tanneries by state.

Find a Taxidermist Near You