GuidesBy Taxidermy Hobbyist Editorial TeamUpdated November 22, 2026

Dermestid Beetles for Skull Cleaning: Starting and Keeping a Colony

Dermestid beetles are the flesh-eating beetles that taxidermists and skull cleaners use to strip a skull down to clean bone without heat or chemicals. Their larvae eat dried tissue out of every crevice without heat, which spares delicate structures such as the thin nasal bones. This guide covers how the beetles work, how to set up and feed a colony, what a starter colony costs, and how to keep the beetles from getting loose in your house.

What are dermestid beetles, and how do they clean skulls?

The dermestid most often used for skull cleaning is Dermestes maculatus, a small beetle whose adults and larvae eat dried animal tissue. The larvae do most of the work. Put a fleshed, air-dried skull in a closed box with a healthy colony and the beetles remove the remaining tissue, leaving clean bone with the teeth still in place.

Kodiak Bones and Bugs, a beetle supplier, calls Dermestes maculatus the species most commonly used for skull preparation, and the University of Arizona Cooperative Extension notes that more than one Dermestes species feeds on dried flesh. The same species is the subject of a 2020 Journal of Forensic Sciences technical note on keeping colonies to clean human remains for forensic work, summarized by the National Institute of Justice. The University of Arizona Cooperative Extension explains that both adult beetles and larvae feed on dried flesh, but the larvae "consume a greater amounts of flesh and are much more efficient bone cleaners" (University of Arizona AZ1144). Adults measure 1/4 to 1/2 inch and are gray to black, sometimes mottled or banded. The larvae have three pairs of legs, a dark gray to almost black color and a fuzzy look.

Are beetles better than simmering or maceration?

Beetles clean skulls very well with little risk of damage: the University of Arizona guide says "the teeth remain in their sockets and skulls usually are not damaged." The drawback is time and upkeep. Simmering is faster but risks heat damage, and maceration is gentle but slow and smelly.

A forum member reported in 2020 that his beetles clean a deer skull in about a day, and that because the skull never sits in water with the meat and brains, he sees less grease and yellowing (forum post, 2020). The Arizona guide gives a wider range: from several hours (small skulls) to several weeks (large ones), depending on skull size, colony size and the temperature in the box. For a full side-by-side of every method, including burial, see simmering, maceration and beetles side by side.

FactorDermestid beetlesSimmeringWarm water maceration
Time per skullHours to weeks (AZ1144)40 minutes to about 8 hours by size (ADFG)About 1 to 2 weeks with a heater (OddArticulations)
TeethStay in socketsLoosen during heating (ADFG)Fall out (OddArticulations)
Bone damage riskLow; small fragile skulls can be damaged if left too longCracks and softening if too hot or too longLow
Ongoing workFeeding, humidity, pest checksNone after the jobDumping and refilling the bucket

How do you set up a dermestid beetle colony?

Set up a dermestid colony in an escape-proof container with screened ventilation, bedding, a water source the beetles cannot drown in, and a steady warm temperature. The University of Arizona guide says the beetles are most active at about 80°F, and the NIJ summary of the 2020 study gives 24 to 27°C with 35 to 73 percent humidity.

  • Container. The Arizona guide says almost any container works: a steel drum, a bucket or even a coffee can. Cover open tops tightly with screen, make wooden box joints tight, and cover any air holes with screen. Kodiak Bones and Bugs, a beetle supplier, recommends "a secure, escape-proof container with smooth interior walls" such as a plastic storage tote (Kodiak Bones and Bugs).
  • Bedding. Arizona suggests placing the skull and beetles between layers of cotton or polyester batting, and notes polyester reduces the chance of carpet moths. Kodiak uses corrugated cardboard to give beetles and larvae surface area.
  • Water. An open bottle or pan of water provides humidity; a cotton wick in it gives the beetles moisture and keeps them from drowning (AZ1144).
  • Temperature. Most active at about 80°F; activity drops sharply when very hot or very cold (AZ1144). Kodiak advises a stable 70 to 80°F.
  • Humidity. The study summary gives 35 to 73 percent. Kodiak warns that humidity must be controlled to prevent mites and mold.

Video walkthroughs help here. Search YouTube for Eremos Outdoors' "Dermestid Beetle Housing Setup/Tips" (2018), Flocken's Nekroparlor's "HOW TO: Build a Simple Dermestidarium" (2021) or New England Naturals' "Ultimate Guide to Setting Up a Dermestid Beetle Enclosure" (2024).

What do dermestid beetles eat, and how do you keep a colony healthy?

Dermestid beetles eat dried animal tissue. Between skulls, the University of Arizona guide says a colony "may be kept alive for quite some time by feeding it dry dog food." Keep the box warm and dry, feed regularly without overfeeding, and check often for mites and fly larvae, which can wipe out a colony.

Hunters who keep colonies describe it as steady work. One forum member wrote in 2019 that a colony must stay warm, be fed fresh rather than rotten meat and be kept free of mites, and that he kept two separate colonies so he always had one going (forum post, 2019). Another said colony size follows food, so save trimmings in a freezer and ask local trappers for carcasses (forum post, 2019).

Kodiak Bones and Bugs advises feeding "dry tissue or properly prepared specimens" and warns that overfeeding causes odor, mold and excess moisture. It also warns that infestations from mites or fly larvae "can quickly devastate a colony" and can be nearly impossible to remove without starting over, which is the main reason to buy from a clean source. The NIJ summary of the 2020 study is blunt about the effort: keeping a colony "can be laborious and time consuming."

How do you prepare a skull for the beetles?

Skin the head, cut away as much meat as you can, remove the eyes and brain, then let the skull air dry before it goes in. The University of Arizona guide says to let a fleshed skull dry somewhere cool and dry first, "generally at least a day or two," because dermestids feed on dried flesh.

Kodiak adds two rules: remove excess food from the box before adding a skull, and avoid wet or rotting specimens, which bring in moisture and mold. Check progress often. Arizona warns that very small and fragile skulls, bird skulls for example, may be damaged if left in the box too long. For the full skinning and fleshing steps on a deer head, see how to clean a deer skull.

Velvet needs protection. A forum member wrote in 2011 that the shop that beetle-cleaned his velvet whitetail skull "had to wrap the velvet so the beetles never ate it" (forum post, 2011).

How do you keep beetles out of your house and your mounts?

Keep beetles in by using a sealed container with fine mesh over every opening, tight joints, and no gaps around the lid. Dermestid beetles as a family are household pests that breed on fur, hair, feathers and preserved animals, so a loose colony puts mounts, hides and furs at risk. Keep the colony away from them.

Colorado State University Extension notes that dermestid beetles "can also be found breeding on items made of fur, hair, feathers, or preserved animals," and advises removing an infested item or, if it can be frozen, to "place it in a deep freezer below 0°F for three days or more," adding that large items need longer freezing times to kill the insects (CSU Extension). The University of Arizona guide stresses tight joints and screened air holes so beetles cannot escape. Kodiak calls for airflow "while preventing outside pests from entering," with fine mesh screens. Our guide to insect damage to finished taxidermy covers how to spot and stop beetle damage on mounts.

Where can you buy dermestid beetles, and what do they cost?

Dermestid beetles are sold as starter colonies of mixed adults and larvae. Kodiak Bones and Bugs Taxidermy lists a 300+ beetle and larvae colony at $65 and a 1,000+ colony at $135, with USPS Priority shipping included (prices read November 21, 2026). Buy from a seller that guarantees mite-free colonies.

Kodiak recommends 300+ beetles for hobbyists and small specimens, and 1,000 to 5,000+ for deer, hog or similar skulls. It says it ships in the beetles' own frass and holds shipments when freezing weather is forecast at the delivery address.

Some of the product links below are affiliate links. Taxidermy Hobbyist may earn a commission on qualifying purchases at no extra cost to you. See our affiliate disclosure.

Colonies are also listed on Amazon: browse dermestid beetle colonies on Amazon and check each seller's mite-free guarantee and live-arrival terms before ordering. The Arizona guide notes that a starter group of adults can also be collected from carcasses left outdoors for a few days, but warns to avoid fly larvae, which "will not do a sufficient job of cleaning skulls" and can stain them. Fly larvae are legless, lighter colored and have no obvious head.

Should you keep a colony or pay a beetle cleaning service?

Keep a colony only if you will clean skulls regularly and can feed it year round. For one or two skulls a season, paying a skull cleaner spares you the upkeep and can cost less than a taxidermist. In one 2022 forum report, a skull cleaner charged $60 where local taxidermists charged $150 to $175.

Another member reported in 2022 that his local beetle business charged $65 to $105 for a bleached pronghorn skull, depending on how much skinning and eye removal prep work the hunter did first. One studio in the table below, True Mount Taxidermy, says it cleans skulls with dermestid beetles.

OptionCostSource
Starter colony, 300+$65 with shippingKodiak Bones and Bugs
Colony, 1,000+$135 with shippingKodiak Bones and Bugs
Beetle cleaning business, pronghorn skull, cleaned and whitened$65 to $105 (forum member report, 2022)forum post
Skull cleaner vs local taxidermists, European mount$60 vs $150 to $175 (forum member report, 2022)forum post
Studio beetle cleaning, whitetail$160True Mount Taxidermy, Quakertown, PA

Ask any service how it actually cleans skulls. A forum member reported in 2020 that a shop said it used beetles and macerated his skull instead (forum post, 2020). Turnaround also varies: a 2019 poster had a moose skull back from a dedicated beetle shop in 8 weeks (forum post, 2019). And a weak colony early in the season may leave the toughest sinew behind, one member warned in 2024 (forum post, 2024).

What do you do with the skull after the beetles?

After the beetles, the skull still needs degreasing and whitening. Beetles remove tissue, not the fat inside the bone. Soak the skull in warm water with dish soap until the grease stops coming out, then whiten it with hydrogen peroxide, never chlorine bleach, and dry it fully before sealing or hanging.

OddArticulations notes that beetle-cleaned bones are usually very greasy, because fats dry and oils soak into the bone while the beetles eat the outside. It degreases in hot water with dish soap and repeats until the bones no longer look greasy (OddArticulations). The University of Arizona guide warns that "Chlorine bleaches should not be used because they can dissolve bone tissue" (University of Arizona AZ1144).

Our guide on how to whiten the skull with peroxide covers strengths and safety, and the complete European mount guide covers degreasing and the rest of the process. When the skull is ready to hang, compare skull plaques and hangers.

Frequently asked questions

How long do dermestid beetles take to clean a deer skull?

Kodiak Bones and Bugs puts a typical deer skull at about one week in an established colony, and one forum member reported in 2020 that his beetles clean a deer skull in about a day. The University of Arizona guide gives several hours for small skulls to several weeks for larger ones, depending on colony size and box temperature.

Can you start a colony from wild beetles?

Yes. The University of Arizona guide says enough adults to start a colony can be collected from carcasses exposed outdoors for a few days. Avoid fly larvae, which are legless, lighter colored and have no obvious head, and keep the new colony warm and fed.

Do dermestid beetles need water?

They need humidity, not standing water they can drown in. The University of Arizona guide uses an open bottle or pan of water with a cotton wick. Too much moisture causes mold and mites, so keep the box warm and fairly dry.

Can beetles clean a bird or small mammal skull?

Yes, and they are well suited to small skulls, but watch them closely. The University of Arizona guide warns that a very small, fragile skull, such as a bird's, can be damaged if it stays in the box too long. Native bird skulls may also fall under the federal rules in the callout above.

Need a Professional?

Browse taxidermy studios, schools, suppliers and tanneries by state.

Find a Taxidermist Near You