GuidesBy Taxidermy Hobbyist Editorial TeamUpdated November 22, 2026

How to Preserve Antlers in Velvet

Velvet antler preservation comes down to timing and the state of the velvet. Velvet that was still tight when the antlers went into the freezer can often be saved; velvet that was already slipping often cannot. Your options are professional freeze drying, a velvet tanning product, home methods some hunters swear by, or replacement velvet. If you want a pro to handle it, find a taxidermist near you before the season starts.

Can velvet antlers still be saved after the kill?

Often yes, if the velvet was still firm on the antler when it was frozen or treated. Loose, slipping velvet is the warning sign. Hunters who have done it say speed matters most: drain what blood you can, keep the antlers cool, and get them to a preservation method fast.

On a 2014 Hunt Talk thread about a velvet mule deer in the freezer, one member asked whether the velvet was "tight" or getting loose when it went in. Loose velvet, he wrote, means "you might be SOL for saving it", while firm velvet "will probably be ok" (Hunt Talk, 2014). His own buck took about 4 days at mild temperatures, around 50 degrees, to reach a freezer, and freeze drying still worked. A member who cures velvet on customers' mounts said he had saved it even when it was dangling, and advised keeping the head frozen until drop-off (Hunt Talk, 2014). A 2011 member who preserves velvet for other hunters said some bucks reached him with the velvet already slipping: "You want to preserve ASAP" (Hunt Talk, 2011).

What should you do in the first hours after the kill?

Puncture the tine tips, push out as much blood as you can, hang the antlers tips down somewhere cool and dry, then either treat or freeze them. One member who has done it says a plan ready for the moment of the kill matters more than the freezer, which buys only a little time.

A 2014 Hunt Talk member said to puncture the vein at each tine tip as soon as the head is caped, then hang the antlers tips down somewhere cool and dry until you can inject or freeze them (Hunt Talk, 2014). In 2021 the member with the 4-day freezer delay said he pricked a caribou's tips, pushed the blood out the base, kept it "cool and dry like meat", and doubted a freezer saves much time, since blood left in the antler can rot: "being ready to preserve and have a plan for immediately after its killed, I think is key" (Hunt Talk, 2021).

Don't count on the freezer to do the preserving. In 2021 a member's taxidermist told him velvet would "freeze dry" in a chest freezer (Hunt Talk, 2021), but a HuntingNet member wrote in 2016 that real freeze drying needs a special vacuum chamber and is not a home job (HuntingNet, 2016). One 2004 HuntingNet member did report preserving 8 or 10 velvet bucks over the years by leaving each one in his own freezer for a year, with no slippage, but all had fully grown antlers (HuntingNet, 2004).

What are the options for preserving velvet?

There are four: professional freeze drying, a velvet tanning or preserving product from a taxidermy supply house, home methods such as denatured alcohol or borax, and replacement velvet applied over stripped antlers. In the threads we read, freeze drying gets the most praise for shape and color.

Professional freeze drying. A 2004 HuntingNet member said a taxidermist friend sends every velvet mount out to be freeze dried, because velvet treated with formaldehyde will in time "crack or shrink" (HuntingNet, 2004). A hunter wrote in 2018 that the velvet antlers of his 1999 mountain caribou, freeze dried after the hunt, still look as they did the day he shot it (HuntingNet, 2018). The 2021 caribou poster on Hunt Talk wrote "Freeze drying seems to preserve the best shape/color" (Hunt Talk, 2021), and another member's taxidermist ships velvet out for freeze drying because he would rather not work with embalming fluid (Hunt Talk, 2021).

Velvet tanning and preserving products. Supply houses sell liquids made for this job, among them Van Dyke's Antler in Velvet Tan, Matuska's Velvet Tan, and VelvaLok, a spray sold at Matuska. The 2011 Hunt Talk member who preserves velvet for others named antler in velvet tan from Van Dyke's (Hunt Talk, 2011), and in 2014 another member's taxidermist recommended a product called stop slip, which the member said can be ordered from Van Dyke's (Hunt Talk, 2014). Directions are in the next section.

Home methods. These are single hunters' accounts, not tests:

  • Denatured alcohol: a 2014 member poured it over his son's velvet several times a day for roughly three days and said it looked unchanged two years later (Hunt Talk, 2014). A 2021 member hangs the antlers upside down, pokes holes in the tips with an awl, and sprays them with denatured alcohol a few times a day for a few days; he added that he doesn't know how it works on soft antlers (Hunt Talk, 2021; follow-up).
  • Borax: a 2014 member sets each cut skull plate, antlers attached, in a tub of borax, and says it dried the velvet without ruining it and kept insects off (Hunt Talk, 2014).
  • Formaldehyde: older HuntingNet posts describe brushing or injecting it. A member who injected a 1982 mule deer reported slippage starting years later (HuntingNet, 2004).

Replacement velvet. Opinions split. One 2014 Hunt Talk member said spray-on velvet "doesn't look natural to me" (Hunt Talk, 2014), while a 2016 HuntingNet member said a spray-on velvet buck at his taxidermist's studio "looks very real" (HuntingNet, 2016). Research Mannikins in Lebanon, Oregon, runs a velvet service for stripped antlers and sheds: its instructions have you strip off the natural velvet, dry the antlers, and send a dried piece of the old velvet as a color sample (Research Mannikins).

How do you use a velvet tanning product?

Thaw the antlers completely, inject the tanning solution at the base until clear fluid comes out of the tips, paint a heavy coat over the velvet, let it hang, then rinse and dry. That is Van Dyke's direction sheet for its Antler in Velvet Tan; a spray product like VelvaLok works differently.

Van Dyke's steps for Antler in Velvet Tan (Van Dyke's):

  1. Thaw frozen antlers fully first; Van Dyke's marks this "Very important".
  2. If the antlers are soft, puncture the tips with a large needle.
  3. Inject the solution into the vein channels around the base until the blood is pushed out of the tips and the fluid runs clear.
  4. Paint on a heavy coat and hang the antlers for 4 days.
  5. Rinse in cool water, hang until dry, then fluff the velvet with a hair dryer or compressed air and a soft brush.

If the velvet has already dried onto the antler, the page says to skip the puncturing and injecting steps and wet the velvet with water before applying.

For VelvaLok, Matuska's product page says to have the head fully thawed with no moisture on it, hold the sprayer no more than 1 inch from the velvet and saturate every crevice, and never put the antlers back in a freezer, because the product needs warmth to set; it calls "80+ degrees" best (Matuska). The page also notes that velvet is living tissue and results depend on antler development and timing.

Some of the product links below are affiliate links. Taxidermy Hobbyist may earn a commission on qualifying purchases at no extra cost to you. See our affiliate disclosure.

Buy the solution from Matuska (Velvet Tan or VelvaLok), or compare velvet antler preservatives on Amazon. Check that the label names velvet antlers.

Can you do a European mount with the velvet on?

Yes, but it takes care: the skull has to be cleaned without soaking, cooking or whitening the velvet. Hunters do it by treating the velvet first and keeping the antler bases out of the water, by wrapping the velvet against beetles, or by cutting the antlers off and reattaching them later.

A 2014 Hunt Talk member posted his velvet euro steps: soak the rack in a strong borax and water solution on the day of the kill and air dry it, freeze the head, cape it and cut off most of the meat, spray two coats of stop slip on the antlers, then clean the skull while "making sure not to submerge antler bases" and whiten it (Hunt Talk, 2014). Another said the shop that beetle-cleaned his velvet whitetail had to wrap the velvet to keep the beetles off it (Hunt Talk, 2011).

The other route is to separate the antlers. One 2014 member sawed his off, sent them away for freeze drying, then cleaned the skull and reassembled it (Hunt Talk, 2014), and in 2021 another cut off the skull cap, cleaned the skull and later reattached the cap with epoxy filling the gaps (Hunt Talk, 2021). For the skull itself, see our European mount guide and European deer mount walkthrough; our antler mounts guide covers displaying a skull cap on its own, and our guide to restoring antler color covers bases that lose color.

What if the antlers were still soft and growing?

Antlers still growing in early summer, like those on a July roadkill buck, are mostly soft tissue, and home methods are much less likely to hold. A HuntingNet member wrote in 2004 that at that stage only freeze drying by a professional "might" work, that alcohol and injection should be forgotten for now, and that a professional could say whether it was worth the money.

That reply, from M.Magis, came on a July 2004 thread about a velvet buck hit by a car. He also told the poster to find out whether keeping antlers from that deer was legal at all (HuntingNet, 2004). An earlier reply pointed out that the formaldehyde successes in the thread were likely on bucks whose antlers were fully grown and hardening (HuntingNet, 2004). In 2021 a Hunt Talk member who treated a car-killed velvet deer wrote "The key is what stage the velvet is in" (Hunt Talk, 2021), and another wrote "Spongy antler could be a problem" (Hunt Talk, 2021).

How much extra does velvet cost?

The three studio price lists we checked in November 2026 add $50, $100 and $250 for velvet on a mount. The one studio that lists both charges $230 for a velvet skull mount against $150 for a plain one. In 2021, one forum member reported paying about $90 for caribou freeze drying and another was quoted $450 for a velvet euro.

Studio or serviceVelvet price, as listedSource
Coots Taxidermy, Las Vegas, NVAntlers in velvet add $50price list
Trophy Taker Taxidermy, Cornelia, GAAny velvet deer add $100; skull mount $150, velvet skull mount $230, velvet skull mount with plaque $280price list
David Martin Taxidermy, Jayess, MSVelvet antlers + $250 (deer)price list
Research Mannikins, Lebanon, OR (velvet service)$100 base plus a charge per bone inch, shipping extraservice page

Prices are from each business's own page, read November 22, 2026. Research Mannikins puts its wait at about 3 weeks. For full mount prices, see our deer taxidermy cost guide.

Forum figures are older, and each is one person's account. A Tennessee hunter wrote in 2021 that his taxidermist charges $100 more than a regular shoulder mount for freeze drying velvet (Hunt Talk, 2021). The same year another hunter was quoted $450 for a velvet euro (Hunt Talk, 2021), and a caribou hunter said his freeze drying cost him "like $90" and took about 30 days (Hunt Talk, 2021). Supplies cost less: Matuska lists a quart of Velvet Tan at $20.35 and VelvaLok at $39.95 to $287.95 by size, and Research Mannikins lists a quart of Antler in Velvet Tan at $21.50, all read November 22, 2026 (Matuska Velvet Tan; Matuska VelvaLok; Research Mannikins).

Frequently asked questions

Does velvet attract bugs after it is preserved?

It can if left untreated. A 2014 Hunt Talk member suggested treating velvet you keep with permethrin or similar, or asking the taxidermist to, so bugs don't eat it (Hunt Talk, 2014). See our guide to insect damage in mounts.

Can you just strip the velvet off instead?

Yes, and some hunters prefer it. The 2021 caribou poster on Hunt Talk said he now usually strips velvet and doesn't worry about it (Hunt Talk, 2021). Research Mannikins' stripping steps soak fresh antlers in salt water, then pressure wash the velvet off (Research Mannikins). If the bare antlers look pale, see restoring antler color.

How long does preserved velvet last?

Members report years: a 1999 caribou still looking new after freeze drying (HuntingNet, 2018), and home alcohol-treated velvet still good after 2 years in one case and almost 20 in another (Hunt Talk, 2014; Hunt Talk, 2021). One 2014 hunter strips all velvet because he finds mounts look worse after a few years (Hunt Talk, 2014).

Need a Professional?

Browse taxidermy studios, schools, suppliers and tanneries by state.

Find a Taxidermist Near You