At the studios checked for this page, a rattlesnake mount is priced by the inch or as a flat fee, and you have three routes: a full mount from a studio, a tanned skin tacked to a board, or a skin you tan yourself. Bauman's Taxidermy in Oklahoma lists a rattlesnake at $12.00 per inch (Bauman's price list); by our arithmetic (48 inches x $12.00), a 4-foot snake there would come to $576. Whichever route you pick, the work starts with handling the dead snake safely and keeping the scales on the skin.
Snake taxidermy sits inside the wider world of the reptile mount, but snakes bring their own problems: fangs that stay dangerous, scales that slip, and a skin that curls as it dries.
What does a rattlesnake mount cost?
Two studios below list a rattlesnake mount, Bauman's at $12.00 per inch and Gateswood at a $450 full price, and All Species and Hicks list snakes in general by the inch, at $14.00 an inch and $21 per inch (the Shoulder column of Hicks' list). Gateswood also tans a rattlesnake skin on a board for less. These are five businesses' own lists, not a market average, and the prices were listed on November 22, 2026. Gateswood's and Hicks' lists both say their prices are subject to change.
| Business | Item as listed | Price as listed |
|---|---|---|
| Bauman's Taxidermy, Anadarko, OK | Rattlesnake | $12.00 per inch |
| All Species Taxidermy and Alligators, Ponchatoula, LA | Snakes (custom or intricate poses and habitat bases cost extra) | $14.00 an inch |
| Gateswood Taxidermy, Robertsdale, AL (its list says prices are subject to change without notice and deposits are non-refundable) | Rattlesnake (mount) | $450 full price, $75 deposit |
| Gateswood Taxidermy | Rattlesnake (on board), tanning | $200 full price, $75 deposit |
| Gateswood Taxidermy | Snake (skin only), tanning | $85 full price, $25 deposit |
| Gateswood Taxidermy | Snake belt (you provide), tanning | $125 full price, $50 deposit |
| Hicks Taxidermy, Northport, AL (its list says all prices are subject to change) | Snake (Shoulder column of its 2026-2027 price list) | $21 per inch ("21/ per inch") |
| Hicks Taxidermy | Snake (Flat Tan column of its 2026-2027 price list) | $800 |
| Lone Star State School of Taxidermy, Llano, TX | 5th Week Rattlesnakes (a course week, not a mount) | $800 |
Per-inch pricing adds up fast on a long snake. By our arithmetic (48 x $12.00 and 48 x $14.00), a 48-inch snake would come to $576 at Bauman's rattlesnake rate and $672 at All Species' snake rate, before any pose or base extras. Gateswood lists "All other snakes" as call for price, and its page says it can't take Alabama rattlesnakes because of Alabama law (Gateswood pricing). The Lone Star State School's $800 rattlesnake week is a class, offered as a breakdown option after you finish its 2 week course (tuition page).
Not every reptile studio takes snakes. Bayou Life Taxidermy in Louisiana mounts alligators but states "No snakes, iguanas, or pet reptiles" on its pricing page. Ask before you drive a frozen snake across the state, and use the taxidermist directory to find shops near you.
Coiled, striking, or a skin on a plaque: which mount should you choose?
Pick by budget and by how much of the snake you have. At Gateswood, whose list says prices are subject to change without notice, a rattlesnake mount lists at $450 and a rattlesnake on board, listed under tanning, at $200. Custom or intricate poses cost extra at All Species, so ask how your studio prices a coiled or striking pose before you commit.
The pose also changes how the snake is skinned. In a video, Chuck Testa of Ojai Valley Taxidermy explains that how far up he cuts often depends on the pose the snake will be mounted in (Chuck Testa, Skinning a Mojave Green). Tell your taxidermist the pose you want before anyone skins it.
A skin on a board is the simplest display. The Furrminator (Jeff Furr) shows one in a video: an already tanned western diamondback skin, about 60 inches long and without the head, tacked down with small aluminum cut tacks on a stained pine board 68 inches long and 10 inches wide (How to Mount a Rattlesnake Skin). He lines up the middle of the diamond pattern with the middle of the board, starts tacking at the middle of the skin and stretches outward to each end, then dabs paint and a marker on the tack heads so they blend in. He also says he keeps it out of direct light.
How do you handle a dead rattlesnake safely?
Treat it as if it can still bite, because it can. The National Capital Poison Center says plainly: "Even a dead snake can envenomate. Do not try to handle a dead snake." (Poison Control).
Forum members back that up from the field. On Rokslide in 2021, member robtattoo advised walking away for 10 minutes once the head is off and leaving the head alone (his post), and member TSAMP, who had killed two snakes in Idaho, replied that he could attest to a detached head still biting (Rokslide thread). Neither post is a lab study, but both match the poison center's warning.
- Move the snake with a shovel or long tool, never your hand near the head.
- If it's going to a taxidermist, leave the head on and tell the shop it's venomous. In Chuck Testa's video he clips out each fang, aiming to take the venom sac with it, and points out that it has backup fangs (video).
- If you're only saving the skin, Van Dyke's SnakeTan directions allow you to skin out the head or cut it off (Van Dyke's).
- If someone is bitten, Poison Control says to get medical care right away and not to try to catch or kill the snake; its phone line is 1-800-222-1222 (Poison Control). For general shop safety, see our taxidermy safety guide.
How do you freeze a snake for the taxidermist?
Bag it tightly, push out the air, and freeze it whole until the studio is ready. Call the shop first and ask how it wants the snake delivered.
The University of Central Oklahoma Natural History Museum's herp preparation guide tells preparers to double bag a specimen and wrap the bags tight with tape or ties, because more layers mean less freezer burn, and to put the data inside the bag written in pencil (UCO guide). That bagging advice sits in the guide's section on skeletal specimens, but the logic carries over. The same guide lists 2 to 4 hours for snakes and lizards to thaw out of the freezer.
If you've already skinned it, one AccurateReloading member, L. David Keith, wrote in 2010 that you can coat the flesh side with borax, roll the skin up, seal it in a zip lock bag with the air pushed out and freeze it (AccurateReloading taxidermy forum).
How do you skin a snake for tanning?
Open it along the belly from the lower jaw to the vent or rattles, peel the skin off the body, and work slowly at the tail and head. Then scrape off every bit of meat and membrane.
- Cut from the center of the lower jaw down to the base of the rattles, per Van Dyke's SnakeTan directions (Van Dyke's).
- Free the skin from the ribs at mid body and work your finger between skin and muscle along each side. The UCO guide notes that the head skin is firmly attached and a little more difficult to remove (UCO guide).
- Go gently at the tail. Chuck Testa calls the vent and the head the two toughest areas and warns about ripping the tail off. In a Real Adventure Theory video, the rattle came off because the skin was pulled inside out like a tube sock too fast (Real Adventure Theory).
- Scrape the flesh side with the side of a tablespoon, then wash the skin in cold water (Van Dyke's). Chuck Testa says most of the meat sits along the belly scales.
How do you tan a snake skin at home?
Use a commercial snake tan if you want a skin you can bend and use. Alcohol and glycerin, borax, or salt will preserve a skin for display, but on Rokslide in 2023 one member found an alcohol and glycerin skin rubbery and another found a salted skin stiff. Whatever you use, keep the skin out of heat and sun.
Some of the product links below are affiliate links. Taxidermy Hobbyist may earn a commission on qualifying purchases at no extra cost to you. See our affiliate disclosure.
Commercial snake skin tanning
Van Dyke's lists WASCO's Tru-Tan Reptile Tan, as a 2 pound kit, at $50.50 and a Wasco Reptile Tanning Kit at $45.50 (Van Dyke's tanning kits, listed on November 22, 2026). Its SnakeTan directions run roughly like this (Van Dyke's SnakeTan):
- Lay the clean skin scale side down, stretch it lengthwise, and pin or staple the edges. Skip the stretching and nailing for a skin you plan to mount.
- Brush on very thin coats, letting each soak in fully, and no more than 2 coats in 18 hours.
- Expect 3 to 8 coats depending on thickness. The skin is done when it feels supple and stops taking in all the tan within 24 hours.
- Wipe both sides with denatured alcohol and let it rest about ten days.
Amazon also sells a snake skin tanning kit and reptile tan. On Rokslide in 2023, member wytx named four products (Snake Tan, Tan A Snake, a Knobloch's reptile tan and a Wasco reptile tan) and said Snake Tan worked fine for him (Rokslide).
Alcohol and glycerin
In the Real Adventure Theory video, Ben mixes denatured alcohol and vegetable glycerin one to one, a cup of each, soaks the scraped skin about three days with a daily stir, then pats it dry, stretches it and pins it out to dry (How to tan snake skin). He says that by tan he means preserve, and a few belly scales still came off his skin. On Rokslide in 2023, member BBob said this method only keeps the skin from rotting and leaves a thick, rubbery texture (Rokslide).
Borax or salt on a board
On Rokslide in 2021, member Wellsdw described pinning the skin scale side down on cardboard, coating it with borax for a couple of weeks, cleaning it off, brushing on satin polyurethane, and mounting it to a plaque (Rokslide). In 2023 member logem said salt on a board gives a stiff skin that isn't practical for most uses (Rokslide). For the chemistry behind tanning in general, see our guide to tanning hides.
What goes wrong when you tan a snakeskin?
The sources above describe five things to plan for: scales coming loose, edges curling, the skin changing size, a bad smell, and damage from heat or harsh chemicals.
- Scale loss. Chuck Testa says the best time to work a snake is right after it sheds, and that one close to a shed will lose scales. Van Dyke's says the skin's condition and the season the snake was killed decide whether the scale sheaths flake off, and suggests scraping loose ones off gently from head to tail with a spoon.
- Curling. The UCO guide pins the skin flesh side up on cardboard over a paper towel about every inch along the edges, which keeps them from curling in, and leaves it a week to dry fully.
- Size change. Chuck Testa notes the skin lets out once it's off the body, because the stacked scales spread. Real Adventure Theory stretches and pins the skin so it dries bigger. If the skin is for a mount, Van Dyke's says not to stretch or nail it.
- Smell. Leatherworker.net member DCKNIVES wrote in 2009 that rattlesnake skins aren't hard to tan but are a bit smelly (Leatherworker.net). Scrape and wash well before tanning.
- Heat and chemicals. Van Dyke's warns in capitals never to expose the skin to heat or sun. On Rokslide in 2023, member Swamp Fox said to watch the soak time with the antifreeze method, recalling a copperhead hide that ended up blue-green (Rokslide).
Once it's finished, keep the skin out of strong light and check it for pests along with the rest of your mounts (see trophy care).
Are some snakes protected?
Yes. Some states protect certain snakes, including the timber rattlesnake, so check before you kill, keep or mount one. Two state agency pages show how this works.
Know the law before you keep a snake.
- Pennsylvania: The Fish and Boat Commission says a permit "is required to hunt, take, catch, kill or possess Timber Rattlesnakes and Eastern Copperhead snakes" (PFBC).
- Connecticut: The timber rattlesnake is listed as endangered, and DEEP says people who kill or collect one "could be faced with fines or legal action" (CT DEEP).
- Alabama: Gateswood Taxidermy, an Alabama studio, says on its price list that because of Alabama laws it cannot do any Alabama rattlesnakes. Ask the Alabama Department of Conservation and Natural Resources before you keep one (Gateswood).
- Found and roadkill snakes: Rules differ by state. Check with your state wildlife agency before you pick one up, and see our summary of taxidermy laws by state.
Snake taxidermy FAQ
How much does taxidermy for a rattlesnake cost?
At the studios checked on November 22, 2026, Bauman's lists a rattlesnake at $12.00 per inch, All Species lists snakes in general at $14.00 an inch with custom poses and habitat bases extra, Hicks lists snakes at $21 per inch in the Shoulder column of a list that says all prices are subject to change, and Gateswood lists a $450 full price for a rattlesnake mount or $200 for a rattlesnake on board, with prices subject to change without notice.
Can you mount a snake that's already been skinned?
Yes, as a skin on a board or plaque, like the already tanned skin in the Furrminator's video above.
Why are the scales falling off my snake skin?
The snake may have been close to shedding when it died. Chuck Testa ties scale loss to shed timing, and Van Dyke's ties it to the skin's condition and the time of year.
Do you need a kit to tan a snake skin?
Not to preserve one for display; alcohol and glycerin or borax will do that. For a skin you plan to bend into a belt or hatband, a commercial snake tan gives the most supple result in the sources above, and Van Dyke's SnakeTan directions include hatbands.
What other reptiles can be mounted?
See the alligator head mount guide, the turtle mount guide, and the main reptile mount page. To pick a studio, read how to choose a taxidermist.